rus
DOI: 10.22184/1992-4178.2022.218.7.146.151
The article describes the initial stage of the research on the creation of a prototype of the domestic technology for 3D printing of printed circuit boards, conducted at the Moscow Aviation Institute under the state order from the Ministry of Science and Higher Education of the Russian Federation. PolyJet inkjet technology is taken as a basis. The task of the initial stage is to develop a method for creating conductive ink from raw materials produced in Russia.
The article describes the initial stage of the research on the creation of a prototype of the domestic technology for 3D printing of printed circuit boards, conducted at the Moscow Aviation Institute under the state order from the Ministry of Science and Higher Education of the Russian Federation. PolyJet inkjet technology is taken as a basis. The task of the initial stage is to develop a method for creating conductive ink from raw materials produced in Russia.
Теги: 3d printing 3d-печать additive technologies conductive ink inkjet printing printed circuit boards resistivity silver nanoparticle ink аддитивные технологии печатные платы проводящие чернила струйная печать удельное сопротивление чернила на основе наночастиц серебра
RESEARCHING INKS FOR 3D PRINTING OF ELECTRONICS: SELECTION OF TECHNOLOGIES
Readers feedback
